Sewage Cleanup Services Our Tower City Team Performs
COS Water Damage Restoration handles the complete scope of Sewage Cleanup in Tower City — from containment and extraction through material removal, sanitization, structural drying, and rebuild. Category 3 protocols, start to finish.
Containment Setup & Source Control
The first action our Tower City sewage crew takes on any Category 3 event is establishing negative-pressure containment — critical plastic sheeting barriers that prevent sewage contamination from spreading into unaffected areas of the property through airborne particles, foot traffic, and air circulation. Containment also controls odor migration within the property while remediation is underway. Simultaneously, we identify and coordinate the correction of the blockage or failure that caused the backup — whether that's a main line obstruction, a failed cleanout, or a sump failure — so that remediation isn't interrupted by a secondary event.
Category 3 Extraction & Material Removal
Extracting Category 3 sewage water from a Tower City property requires specific PPE — full protective suits, respirators rated for biological hazard, and disposable boots — for every technician in the contamination zone. We use dedicated contaminated-water extraction equipment that is not shared with standard water damage jobs and is properly sanitized between uses. After extraction, all materials that contacted Category 3 water and cannot be decontaminated to a safe standard — carpet, pad, standard drywall, fiberglass insulation, and any non-cleanable surface materials — are removed as regulated waste, bagged in approved containers, and disposed of under PA biohazard material regulations.
Multi-Phase Antimicrobial Sanitization
After material removal, every remaining structural surface — framing, subfloor sheathing, masonry, concrete, and any hard surface that contacted sewage water in your Tower City property — receives a multi-phase sanitization treatment using EPA-registered, hospital-grade antimicrobial and antifungal agents. The sanitization sequence includes spray application, documented dwell time, surface contact, and at minimum one additional application after the first dwell cycle. This is not a one-spray process. The S520 protocol our Tower City team follows is designed to address the pathogen load that Category 3 water deposits on structural surfaces.
Odor Neutralization & Air Treatment
Category 3 sewage events leave odor-causing compounds embedded in structural materials, in the air space above the affected area, and — in HVAC systems — potentially distributed throughout the property. Our Tower City team uses hydroxyl generator technology and botanical-based counteractant treatments to neutralize sewage odor compounds in the air and on surfaces, not mask them. For properties where HVAC ductwork may have been exposed to Category 3 contamination, duct isolation and decontamination is included in our scope evaluation.
Insurance & Backup Coverage Claims
Our Tower City claim coordinators have processed Category 3 claims across PA carriers. We know what gets approved on first submission.
Post-Remediation Reconstruction
After Category 3 remediation is confirmed complete by instrument readings and — where required — by third-party clearance testing, our licensed Tower City reconstruction team rebuilds your property: new drywall, fresh insulation, flooring, paint, trim, and any affected cabinetry or millwork. All reconstruction is performed to the same documentation standard as the remediation phase, providing a complete recovery record from sewage event to finished property that your insurance carrier and any future property transaction will find clear and complete.
